9041883

1.

Many malfunctions in the electrical system are caused by poor harness(es) and terminal condition. Faults can also be caused by interference from other electrical systems, and mechanical systems or chemical damage.

2.

Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.

3.

Has a problem been found?

	▶ Repair or replace as necessary and then, Go to "Verification of Vehicle Repair" procedue.
	▶ Go to "PAS Switch Indicator Circuit Inspection" Procedure.

1.

Ignition "ON" & Engine "OFF"

2.

Disconnect the PAS Switch connector.

3.

Measure the voltage between Pin No.4(IND power) of the Console switch harness connector and chassis ground.

Specification : Battery (+) Voltage

Fig.1) GDS Multimeter voltage check

4.

Is the measured voltage within specifications?

▶ Fault is intermittent caused by poor contact in the switch and/or SPAS ECU connector or was repaired and SPAS ECU memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure.

▶ Carefully re-do this troubleshooting guide steps.

▶ Repair or replace as necessary and go to "Verification of Vehicle Repair" procedure.

▶ If no problems were found with the circuits or connectors, replace the PAS switch and go to "Verification of Vehicle Repair" procedure.