3.
Perform "Actuation Test" for ETC Motor.
Specification : Check the TPS1 change in value
Fig.1) ETC Motor Actuation Test
Connect GDS to Data Link Connector(DLC).
IG KEY "ON" & ENG "OFF".
Perform "Actuation Test" for ETC Motor.
Specification : Check the TPS1 change in value
Fig.1) ETC Motor Actuation Test
IG Key "OFF".
Disconnect ETC Motor connector.
Measure resistance between power and control terminal of the ETC Motor. (Component Side)
Fig.1) 'Zero Set' Function
Specification : Approx. 1.2 ~ 1.8 [20°C(68 °F)]
Does the ETC Motor operate properly? (Check variation)
 | ▶ Go to "Verification of Vehicle Repair" procedure. |
 | ▶ Carefully re-do this troubleshooting guide steps. ▶ If no problems were found with the circuits or connectors, replace the ETC and go to "Verification of Vehicle Repair" procedure. |
