Component Inspection
1.

IG "OFF" and disconnect the clutch switch connector.

2.

Measure resistence between 1 teminal and 2 terminal when clutch switch is ON or OFF.

Specification : Below 1 Ω(ON) and ∞(OFF)

3.

Is the measured resistence within specification?

▶ Go to "Verification of Vehicle Repair" procedure.

▶ Carefully re-do this troubleshooting guide steps.

▶ If no problems were found with the circuits or connectors, replace the Clutch Switch and go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика