Component Inspection
1.

Ignition switch "OFF"

2.

Connect VMI to GDS and set up the Oscilloscope.(2 Channel):

Channel A (+) : Pin No. 4 (EOPS Signal) terminal (EOPS Harness Connector)

Channel A (-) : Ground

3.

Ignition switch "ON" & Engine "OFF"

4.

Inspection condition : Ignition switch "ON" or Engine "OFF"

Specification : Approx. 0.5V

※ Sensor signal voltage increases in proportion to engine oil pressure.

5.

Is the measured value within specification?

▶ Fault is intermittent caused by poor contact in the sensor’s and/or ECM’s connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of vehicle Repair" procedure.

▶ Carefully re-do this troubleshooting guide steps.

▶ If no problems were found with the circuits or connectors, replace the EOPS and go to "Verification of Vehicle Repair" procedure.

caution
•

When installing component, tighten it within specification

•

If component is dropped, check for proper operation. The internal damage may be present

Яндекс.Метрика