Component Inspection
■ Crankshaft Position Sensor(CKPS) Coil Resistance Inspection
1.

Ignition switch "OFF"

2.

Disconnect batter (-) cable.

3.

Refer to "Shop Manual" and disconnect CKPS connector.

4.

Measure the resistance between Pin No. 3 (CKPS Signal Plus) and Pin No. 2 (CKPS Signal Minus) terminal of CKPS harness connector.

Specification : 744 - 946 [20℃(68℉)]

5.

Is the measured value within specification?

▶ Fault is intermittent caused by poor contact in the sensor’s and/or ECM’s connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of vehicle Repair" procedure.

▶ Carefully re-do this troubleshooting guide steps.

▶ If no problems were found with the circuits or connectors, replace the CKPS and go to "Verification of Vehicle Repair" procedure.

caution
•

When installing component, tighten it within specification.

•

If component is dropped, check for proper operation. The internal damage may be present.

Яндекс.Метрика