9047057

1.

Ignition "ON" & Engine "OFF".

2.

Connect scan tool and select "Diagnostic Trouble Codes(DTC)" mode.

3.

Using a scantool, Clear DTC.

4.

IG OFF ↔ IG ON (Repeat 2~3times),and then Monitor the "DTC".

5.

Is DTC Re-displayed ?

	▶ Substitute with a known-good TCM and check for proper operation. If the problem is corrected, replace TCM and then go to "Verification of Vehicle Repair" procedure.
	▶ Fault is intermittent caused by poor contact in the sensor's and/or TCM's connector or was repaired and TCM memory was not cleared. And Go to Component Inspection procedure.