3.
Monitor the "TCU Voltage" parameter on the "Current Data" with GDS.
■ Specification : approx. 12V
FIG1) "TCU Voltage"
Connect GDS to Data Link Connector(DLC).
Engine "ON".
Monitor the "TCU Voltage" parameter on the "Current Data" with GDS.
■ Specification : approx. 12V
FIG1) "TCU Voltage"
Does "TCU Voltage" follow the referance data?
 | ▶ Fault is intermittent caused by poor contact in the sensor's and/or TCM's connector or was repaired and TCM memory was not cleared. Throughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.Repair or replace as necessary and go to "Verification Vehicle Repair" procedure. |
 | ▶Go to "W/Harness Inspection" procedure. |
