4.
Move selector lever from "P" range to "D" range.
FIG1)"P" & "D" range.
FIG2)"R" range.
FIG3)"D" range.
Connect GDS to Data Link Connector(DLC).
Ignition "ON" & Engine "OFF".
Monitor the "TGS sensor" parameter on the "Current Data" with GDS.
Move selector lever from "P" range to "D" range.
FIG1)"P" & "D" range.
FIG2)"R" range.
FIG3)"D" range.
Does "TGS sensor" follow the referance data?
 | ▶ Fault is intermittent caused by poor contact in the sensor's and/or TCM's connector or was repaired and TCM memory was not cleared. Throughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.Repair or replace as necessary and go to "Verification Vehicle Repair" procedure. |
 | ▶Go to "W/Harness Inspection" procedure. |
