4.
Is resistance within specifications?
 | ▶ Go to "CHECK TCM " as below. |
 | ▶ Replace "INPUT SPEED SENSOR" as necessary and Go to "Verification Vehicle Repair" procedure. |
Ignition "OFF".
Disconnect the "INPUT SPEED SENSOR2" connector.
Measure resistance between terminal "1","3" of the "INPUT SPEED SENSOR2" connector.
Specification :20~30 MΩ
[1. Signal, 2. -, 3. Power]
Is resistance within specifications?
| ▶ Go to "CHECK TCM " as below. |
| ▶ Replace "INPUT SPEED SENSOR" as necessary and Go to "Verification Vehicle Repair" procedure. |
Ignition "ON" & Engine "OFF".
Disconnect the "INPUT SPEED SENSOR2" connector.
Install scantool and slect a "Simulation".
Simulate frequency to INPUT SPEED SENSOR2 signal circuit.
FIG1) 150Hz → 255rpm
FIG2) 250Hz →425rpm
The values are subject to change according to vehicle model or conditions.
Is "INPUT SPEED SENSOR2" signal value changed according to simulation frequency?
| ▶ Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
| ▶ Substitute with a known-good TCM and check for proper operation. If the problem is corrected, replace TCM and then go to "Verification of Vehicle Repair" procedure. |
