4.
Perform "DCT Manual Learning" on the "Vehicle S/W Management" with GDS.
FIG1) DCT Manual Learning - Warning
FIG2) DCT Manual Learning - Step 1
FIG3) DCT Manual Learning - Step 2
FIG4) DCT Manual Learning - Step 3
Connect GDS to Data Link Connector(DLC).
Ignition "ON", Engine "OFF".
Erase the "DTC code" use GDS.
Perform "DCT Manual Learning" on the "Vehicle S/W Management" with GDS.
FIG1) DCT Manual Learning - Warning
FIG2) DCT Manual Learning - Step 1
FIG3) DCT Manual Learning - Step 2
FIG4) DCT Manual Learning - Step 3
Does "DCT Manual Learning" performed normally?
 | ▶ Fault is intermittent caused by poor contact in the sensor's and/or TCM's connector or was repaired and TCM memory was not cleared. Throughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration or damage.Repair or replace as necessary and go to "Verification Vehicle Repair" procedure. |
 | ▶ Replace "DCT" and then go to "Verification of Vehicle Repair" procedure. caution
–
Be aware of Battery discharge, When does the "DCT Manual Learning" perform continuously because 4 motors is operated so current consuption is increase. Check the Engine condition before "DCT Manual Learning" because Engine rpm increase to 6000rpm When does the "DCT Manual Learning" performing. |
