5.
Monitor "Shift Motor 2 Position(Even Gear Shaft)" in "Current Data" with GDS.
Specification : Refer to Figure below
Fig.1) Engage Even Gear (2nd Gear) Actuation Test
Ignition "OFF"
Connect GDS to Data Link Connector(DLC).
Ignition "ON"
Perform "Engage Even Gear (2nd Gear)" in "Actuation Test" with GDS.
Monitor "Shift Motor 2 Position(Even Gear Shaft)" in "Current Data" with GDS.
Specification : Refer to Figure below
Fig.1) Engage Even Gear (2nd Gear) Actuation Test
Perform "Lug Alignment" in "Actuation Test" with GDS.
Specification : Check for operation sound
Fig.2) Lug Alignment Actuation Test
Perform "Gear Actuator Reference Check" in "Actuation Test" with GDS.
Specification : Check for operation sound
Fig.3) Gear Actuator Reference Check Actuation Test
Is displayed parameter within specification?
 | ▶ Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage. ▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
 | ▶ Carefully re-do this troubleshooting guide steps. ▶ If problem still occurs, repair or replace Gear Shift assembly and then go to "Verification of Vechicle Repair" procedure.(Perform "DCT Learning" in "Vehicle S/W Management " with GDS.) ▶ Replace "DCT" and then go to "Verification of Vehicle Repair" procedure.(Perform "DCT Manual Input Function(Transmission Exchange)" in "Vehicle S/W Management " with GDS.) |
In case of replacing TCM or Clutch pack perform following procedures;
Ignition switch "OFF"
Connect GDS to Data Link Connector (DLC).
Ignition switch "ON"& Engine "OFF"
Select the "Vehicle S/W Management" about related DTC with GDS.
Perform "DCT Learning" in "Vehicle S/W Management " with GDS.
Fig.1) Vehicle S/W Management
Fig.2~5) DCT Learning Function - Step 1~5
Fig.6) DCT Learning Function Completed
In case of replacing DCT perform following procedures;
Ignition switch "OFF"
Connect GDS to Data Link Connector (DLC).
Ignition switch "ON"& Engine "OFF"
Select the "Vehicle S/W Management" about related DTC with GDS.
Perform "DCT Manual Input Function(Transmission Exchang)" in "Vehicle S/W Management " with GDS.
Fig.1) Vehicle S/W Management
Fig.2~3) "DCT Manual Input Function(Transmission Exchang)" - Step 1~2
Fig.4) "DCT Manual Input Function(Transmission Exchang)" Completed
