Ignition "OFF"
Refer to "Shop Manual" and remove inhibitor switch.
Check for continuity between power terminal and each gear signal terminal(P, R, N, D) of inhibitor switch.
Specification :
"P" Gear : Continuity check between power terminal and "P" gear signal terminal of inhibitor switch. [Approx. 0.3 Ω (Vehicle Test)]
"R" Gear : Continuity check between power terminal and "R" gear signal terminal of inhibitor switch. [Approx. 0.3 Ω (Vehicle Test)]
"N" Gear : Continuity check between power terminal and "N" gear signal terminal of inhibitor switch. [Approx. 0.3 Ω (Vehicle Test)]
"D" Gear : Continuity check between power terminal and "D" gear signal terminal of inhibitor switch. [Approx. 0.3 Ω (Vehicle Test)]
Is measured value within specification?
 | ▶ Carefully re-do this troubleshooting guide steps. ▶ If problem still occurs, replace TCM and then go to "Verification of Vechicle Repair" procedure. |
 | ▶ Carefully re-do this troubleshooting guide steps. ▶ If problem still occurs, replace Inhibitor Switch and then go to "Verification of Vechicle Repair" procedure. |
