TCM set this code when gear is not correct engaged.
Item | Detecting Condition | Possible Cause |
DTC Strategy |
•
There is enough force on shift motor1 but not enough motion of gear actuator finger is detected while engaging 1st gear | 1. Defected Gear shift assembly 2. Defected DCT 3. Mechanical failure on gear1 shift direction |
Enable Condition |
•
When 1st gear is engaged
•
Battery Voltage higher than 10V
•
Shift motor 1 Voltage higher than 9V
•
No electrical failure on shift motor 1 | |
Threshold Value |
•
Shift motor 1 force higher than 900N
•
Shift motor 1 motion less than 0.1419mm | |
Fail Safe |
•
Drive at Even gear | |
Detecting Time |
•
3 events | |
MIL ON Condition |
•
2nd Driving Cycle |
