3.
Remove the installation bolt (B), and then remove the crankshaft position sensor.
Check signal waveform of CKPS and CMPS using a GDS.
Specification: Refer to “Waveform”
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Disconnect the crankshaft position sensor connector (A).
Remove the installation bolt (B), and then remove the crankshaft position sensor.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
When you install the dust cover, stick it to the block. And then must check the sensor cable whether seperating.
Installation is reverse of removal.
Crank shaft position sensor installation bolt:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
