2.
Remove the air duct (A).
Turn the ignition switch OFF and disconnect the battery (-) cable.
Remove the air duct (A).
Disconnect the boost pressure sensor connector (A).
Removal the boost pressure sensor (B) after removing the installation bolts.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Installation is reverse of removal.
Boost pressure sensor installation bolt:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
