4.
Remove the installation bolt (B), and then remove the sensor from the cylinder block.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold")
Disconnect the injector connector (A).
Remove the installation bolt (B), and then remove the sensor from the cylinder block.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
Installation is reverse of removal.
Knock sensor installation bolt:
18.6 ~ 24.5 N.m (1.9 ~ 2.5 kgf.m, 13.7 ~ 18.1 lb-ft)
