1.
Install the cable retainer (A).
Tightening torque :
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
Install the cable retainer (A).
Tightening torque :
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
Install the heater unit.
(Refer to Heating,Ventilation, Air Conditioning - "Heater Unit")
Install the crash pad and cowl cross bar.
(Refer to Body - "Cowl Cross Bar Assembly")
Install the control cable soket (A).
Install the shift cable ( B) to the shift lever after intalling the snap pin (A).
Insert the snap pin after installing the select cable (A) to the shift lever.
Install the floor console assembly.
(Refer to Body - "Floor Console")
Install the boots (A) to the console after Installing the knob (B) by rotating clockwise.
Install the control cable.
Check that the shift lever and control shaft are placed in the "4th" position.
Install the control cable to the cable bracket.
After pulling the holder (A) in the direction of the "P", pull the lock (B) in the direction of the "F".
Push the lock (C) after installing the control cable to the control shaft.
Insert the snap pin (A).
Install the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
Install the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
