5.
Loosen the shift cable mounting nut (B).
Disconnect the Inhibitor switch connector.
Turn ignition key "ON", & engine "OFF".
Measure voltage between supplied power and ground at inhibitor switch circuit.
Specification: Approx. 12V
Connect the Inhibitor switch connector.
Turn ignition key "ON", & engine "OFF".
Measure the voltages between each terminal and chassis ground in each range (P, R, N, D).
| P | P-R | R | R-N | N | N-D | D |
Signal "1" | 12V | 12V | 0 | 0 | 0 | 0 | 0 |
Signal "2" | 0 | 12V | 12V | 12V | 0 | 0 | 0 |
Signal "3" | 0 | 0 | 0 | 12V | 12V | 12V | 0 |
Signal "4" | 0 | 0 | 0 | 0 | 0 | 12V | 12V |
Place the shift lever in the "N" position.
Disconnect the battery negative (-) cable.
Remove the air duct and the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
Disconnect the inhibitor switch connector (A).
Loosen the shift cable mounting nut (B).
Remove the manual control lever (A).
Remove the inhibitor switch (A).
Check that the shift lever is placed in the "N" position.
Install the inhibitor switch (A).
Lightly tighten the inhibitor switch mounting bolts so that necessary adjustments can be made.
Install the manual control lever (A).
Lightly tighten the manual control lever nut so that necessary adjustments can be made.
Align the hole (B) in the manual control lever with the "N" position hole (A) of the inhibitor switch and then insert the SST inhibitor switch guide pin (09480-A3800).
Tighten the nut (A) to the specified torque.
Tightening torque :
17.7 ~ 24.5 N.m (1.8 ~ 2.5 kgf.m, 13.0 ~ 18.1 lb-ft)
Tighten the bolts (B) to the specified torque.
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Remove the SST (09480-A3800) from the adjusment hole.
Connect the inhibitor switch connector (A).
Install the shift cable by tightening nut (B).
Tightening torque :
9.8 ~ 13.7 N.m (1.0 ~ 1.4 kgf.m, 7.2 ~ 10.8 lb-ft)
Install the air duct and the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
Connect the battery negative (-) cable.
