3.
Measure resistance between PCSV terminals 1 and 2.
Turn ignition switch OFF.
Disconnect PCSV connector.
Measure resistance between PCSV terminals 1 and 2.
Check that the resistance is within the specification.
Specification: Refer to “Specification”
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Remove the air cleaner.
(Refer to Engine Mechanical System - " Air Cleaner")
Remove the battery.
(Refer to Engine Electric System - "Battery")
Disconnect the purge control solenoid valve connector (A) and vapor hoses (B).
Remove the purge control solenoid valve (C).
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Be careful of foreign material not to flow into the valve.
Installation is reverse of removal.
