2.
Disconnect the ETC connector (A) and then by loosening the mounting bolts (B), widen the gap between the ETC module from the intake manifold to remove the variable intake solenoid valve.
Turn the ignition switch OFF.
Disconnect the VIS valve connector.
Measure resistance between VIS valve terminals 1 and 2.
Specification: Refer to "Specification"
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Disconnect the ETC connector (A) and then by loosening the mounting bolts (B), widen the gap between the ETC module from the intake manifold to remove the variable intake solenoid valve.
Remove the variable intake solenoid valve (A).
Disconnect the variable intake solenoid valve connector (A).
Disconnect the vacuum hoses (B) from the valve.
Remove the variable intake solenoid valve (C).
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Be careful of foreign material not to flow into the valve.
Installation is reverse of removal.
