3.
Check motor operation by fuel pump connector (A) connecting power (No.4) and ground (No.5).
Pin No. | Description |
1 | Fuel sender signal (+) |
2 | - |
3 | Fuel sender ground (-) |
4 | - |
5 | Fuel pump motor (+) |
6 | Fuel pump motor (-) |
Turn the ignition switch OFF, and then remove battery (-) terminals.
Remove the fuel pump assembly.
Check motor operation by fuel pump connector (A) connecting power (No.4) and ground (No.5).
Pin No. | Description |
1 | Fuel sender signal (+) |
2 | - |
3 | Fuel sender ground (-) |
4 | - |
5 | Fuel pump motor (+) |
6 | Fuel pump motor (-) |
Turn the ignition switch OFF, and then remove battery (-) cable.
Remove the fuel pump assembly.
Using an ohmmeter, measure the resistance between terminals 1 and 3 of sender connector (A) at each float level.
Pin No. | Description |
1 | Fuel sender signal (+) |
2 | - |
3 | Fuel sender ground (-) |
4 | - |
5 | Fuel pump motor (+) |
6 | Fuel pump motor (-) |
Also check that the resistance changes smoothly when the float is moved from "E" to "F".
Position | Resistance(Ω) | Capacity (ℓ) |
E | 197 ~ 203 | 3.0 |
1/2 | 64.2 ~ 68.2 | 26.0 |
F | 6 ~ 10 | 51.9 |
Release the residual pressure in fuel line
(Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line").
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Fold the rear seat cushion (A).
Open the service cover (A) after loosening the screws (B).
Disconnect the fuel pump connector (A), fuel feed tube quick connector (B) and the vapor tube quick-connector (C).
Remove the fuel pump plate cover (D) after removing the bolts.
Fuel pump plate cover mounting bolt :
1.96 ~ 2.94 N.m (0.2 ~ 0.3 kgf.m, 1.45 ~ 2.17 lb-ft)
Remove the fuel pump (A).
Install in the reverse order of removal.
Be careful of fuel pump direction when installing (Refer to the groove in the fuel tank).
