4.
Remove the installation nut (B-2ea), and then disconnect the fuel feed tude (A).
Release the residual pressure in fuel line.
(Reter to Fuel Delivery System - "Release Residual Pressure in Fuel Line")
Turn the ignition switch OFF, and then remove the battery negative (-) terminal.
Remove the air cleaner.
(Refer to Engine Mechanical System - "Air Cleaner")
Remove the installation nut (B-2ea), and then disconnect the fuel feed tude (A).
Disconnect the vapor hose (A) which is connected from the PCSV.
Remove the fuel tank.
(Refer to Fuel Delivery System - "Fuel Tank")
Remove the sub frame.
(Refer to Suspension System - "Sub Frame")
Release the brake pipe after disconnect the the brake pipe line (A).
After installation, bleed the brake system.
(Refer to Brake System - Operation and Leakage Check - "Bleeding of Brake System")
Remove the fixing clips (A).
Remove the brake & fuel line protect (A).
Remove the fuel line (A).
Do not use already used injector fixing clip again.
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Install in the reverse order of removal.
