2.
Disconnect the crankshaft position sensor connector (A).
Check signal waveform of CKPS and CMPS using a GDS.
Specification: Refer to "Waveform"
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Disconnect the crankshaft position sensor connector (A).
Remove the engine room under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
Remove the sensor (A) by loosening the mounting bolt.
Tighten the component to the specified torques.
If the component has been dropped, inspect for damage before installation.
Apply engine oil to the O-ring.
Carefully insert the sensor into the installation hole without damaging it.
Install in the reverse order of removal.
Crankshaft position sensor mounting bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
