3.
Remove the sensor by loosening the mounting bolt (B).
Check the signal waveform of the CMPS and CKPS using the GDS.
Specification: Refer to “Wave Form”
DO NOT remove the camshaft position sensor while the engine is running or immediately after turning off the engine as the part and engine oil are hot and can cause burns.
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Disconnect the camshaft position sensor connector (A).
Remove the sensor by loosening the mounting bolt (B).
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Remove the battery.
(Refer to Engine Electrical System - "Battery")
Disconnect the camshaft position sensor connector (A).
Remove the sensor (A) by loosening the mounting bolt (B).
Install the component to the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
Apply engine oil to the O-ring.
Carefully insert the sensor into the installation hole without damaging it.
Be careful not to damage the sensor housing and the connector.
Be careful not to damage the O-ring.
Install in the reverse order of removal.
Camshaft position sensor mounting bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
