4.
Disconnect the crankshaft position sensor connector (A).
Check signal waveform of CKPS and CMPS using a scan tool.
Specification: Refer to “Waveform”
Turn ignition switch OFF and disconnect the battery negative (-) terminal.
Remove the air cleaner.
(Refer to Engine Mechanical System - "Air Cleaner")
Remove the battery.
(Refer to Engine Electrical System - "Battery")
Disconnect the crankshaft position sensor connector (A).
Lift the vehicle.
Remove the CKP sensor after removing the installation bolt (A).
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped.
If the component has been dropped, inspect before installing.
Apply the engine oil to the O-ring.
Insert the sensor in the installation hole and be careful not to damage.
Installation is reverse of removal.
Crankshaft position sensor installation bolt:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
