4.
Remove the connector (A), and then separate the injector (B) from the delivery pipe.
Turn the ignition switch OFF.
Disconnect the injector connector.
Measure resistance between the injector terminals 1 and 2.
Check that the resistance is within the specification.
Specification: 1.5 ± 0.075 [20℃(68℉)]
When removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there is potential risk of injury caused by leakage of the high pressure fuel. So, do not work on related parts immediately after engine stops.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”)
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Remove the delivery pipe & injector assembly.
(Refer to Fuel Delivery System - “Delivery Pipe")
Remove the connector (A), and then separate the injector (B) from the delivery pipe.
Combustion seal
Rubber washer
Support disc
O-ring
Do not reuse the injector fixing clip.
Install the component to the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
Apply engine oil to the injector O-ring.
Do not reuse the injector O-ring.
Do not reuse the bolt.
When inserting the injector, be careful not to damage the injector tip.
Do not reuse the support disc.
Do not reuse the injector rubber washer.
When replacing the rubber washer, the steal plate (A) part should face the cylinder installation part and the rubber plate (B) part should face the injector body part.
Do not reuse the combustion seal.
Install in the reverse order of removal.
The injector combustion seal should be replaced with a new one to prevent leakage after removing the injector.
Remove the combustion seal (A) with a wire cutter.
By pinching the sealing ring, carefully pull it to form a small loop and then cut it out.
Be careful not to damage the surface of the valve sleeve with the wire cutter.
Before the assembly of the sealing ring, the groove must be cleaned by using a clean cloth.
By using a brass-wire brush, carefully remove all caulking from the injector sealing surface.
The surfaces of the new sealing ring must be clean and free of grease.
Place the seal installing guide (B) (SST No.: 09353-2B000) on the tip of the injector without damaging the injector tip (A).
Push the sealing ring (C) by thumb and index finger over the conical assembly tool until it snaps into the groove.
The complete assembly must not take longer than 2 to 3 seconds.
To size the sealing ring, the injector is first introduced to the sizing tool (A) (SST No.: 09353-2B000) and then pressed and rotated 180° at the same time into the sizing tool.
Pull the injector out of the sizing tool by turning it in the reverse direction of the press-in process.
Make sure that the seal ring is not been damaged during assembly to the injector and that no circumferential scratches are present.
Do not reuse the combustion seal.
The seal must be completely free of grease and oil.
Check the combustion seal (A) installation.
