3.
Remove the sensor (B) from the Intake manifold by loosening the mounting screws.
Connect the GDS on the Data Link Connector (DLC).
Measure the output voltage of the MAPS at idle and IG ON.
Pressure [kPa (kgf/cm², psi)] | Output Voltage (V) [Vref=5V] |
32.5 (0.33, 4.71) | 0.5 |
284 (2.90, 41.19) | 4.5 |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Disconnect the manifold absolute pressure sensor connector (A).
Remove the sensor (B) from the Intake manifold by loosening the mounting screws.
Tighten the component to the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, if it is damaged inspect before installing.
Carefully insert the sensor into the installation hole without damaging it.
Install in the reverse order of removal.
Manifold absolute pressure sensor mounting screw :
6.4 ~ 8.3 N.m (0.65 ~ 0.85 kgf.m, 4.7 ~ 6.1 lb-ft)
