Release the residual pressure in fuel line.
(Reter to Fuel Delivery System - "Release Residual Pressure in Fuel Line")
Turn the ignition switch OFF, and then remove the battery negative (-) terminal.
Disconnect the fuel feed tube quick-connector (A) and vapor hose (B).
Open the clamp cover (B) before disconnecting the quick connector (if the clip is applied).
When removing the quick-connector by using a clip removing tool (A), be careful not to damage the plastic clip (B).
If the clip is damaged, fuel line leakage may occur due to poor connection.
Remove the air cleaner.
(Refer to Engine Mechanical System - "Air Cleaner")
Remove the fuel tank.
(Refer to Fuel Delivery System - "Fuel Tank")
Remove the sub frame.
(Refer to Suspension System - "Sub Frame")
Remove the fuel tube clamp mounting bolt (A).
Release the brake pipe after disconnecting the the brake pipe line (A).
After installation, bleed the brake system.
(Refer to Brake System - Operation and Leakage Check - "Bleeding of Brake System")
Remove the fixing clips (A).
Remove the brake & fuel line protect (A).
Remove the fuel line (A).
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”)
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Remove the air cleaner and the air intake hose.
(Refer to Engine Mechanical System - “air cleaner”)
Remove the engine control wiring.
Remove the vacumm pipe (A).
Remove the flange nut (A) from the high pressure fuel pump by using the special service tool [SST No.: 09314-3Q100 or 09314-27130].
High pressure fuel pipe flange nut:
26.5-32.4 N.m (2.7-3.3 kgf.m, 19.5-23.9 lb-ft)
Remove the flange nut (A) from the delivery pipe by using the special service tool (B) [SST No.: 09314-3Q100 or 09314-27130].
High pressure fuel pipe flange nut:
26.5-32.4 N.m (2.7-3.3 kgf.m, 19.5-23.9 lb-ft)
Disconnect the engine coolant temperature sensor connector.
Remove the function block after loosening the mounting bolt, and then remove the high pressure fuel pipe (A).
High pressure fuel pipe function block mounting bolt:
9.8-11.8 N.m (1.0-1.2 kgf.m, 7.2-8.7 lb-ft)
Do not reuse injector fixing clip.
Install the component to the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Install in the reverse order of removal.
