5.
Remove the injector & delivery pipe form (A).
In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair work right after engine stops.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”)
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Remove the engine oil gauge.
(Refer to Engine Mechanical System - "Oil Level Gauge & Pipe")
Remove the intake manifold.
(Refer to Engine Mechanical System - "Intake Manifold")
Remove the injector & delivery pipe form (A).
Remove the flange nut (A) from the high pressure fuel pump by using the special service tool [SST No.: 09314-3Q100 or 09314-27130].
High pressure fuel pipe flange nut:
26.5-32.4 N.m (2.7-3.3 kgf.m, 19.5-23.9 lb-ft)
Remove the delivery pipe & injector assembly after loosening the mounting bolts (A).
Delivery pipe & injector mounting bolt:
18.6-23.5 N.m (1.9-2.4 kgf.m, 13.7-17.4 lb-ft)
Remove the connector (A), and then separate the injector from the delivery pipe (B).
