3.
Measure resistance between sensor signal terminal and ground terminal.
EGTS #1
EGTS #2
Turn ignition switch OFF.
Disconnect the exhaust gas temperature sensor #1/#2 connector.
Measure resistance between sensor signal terminal and ground terminal.
Check that the resistance is within the specification.
Temperature [℃(℉)] | Resistance(㏀) |
100(212) | 289.0 ~ 481.0 |
300(572) | 5.30 ~ 6.61 |
600(1,112) | 0.35 ~ 0.38 |
900(1,652) | 0.08 ~ 0.09 |
Temperature [℃(℉)] | Resistance(㏀) |
100(212) | 289.0 ~ 481.0 |
300(572) | 5.30 ~ 6.61 |
600(1,112) | 0.35 ~ 0.38 |
900(1,652) | 0.08 ~ 0.09 |
Turn the ignition switch OFF and disconnect the battery (-) cable.
Disconnect the exhaust gas temperature sensorconnector (A).
Remove the exhaust gas temperature sensor (B).
Turn the ignition switch OFF and disconnect the battery (-) terminal.
Disconnect the exhaust gas temperature sensor connector (A).
Remove the exhaust gas temperature sensor (B).
Install the component with the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Installation is reverse of removal.
Exhaust gas temperature sensor :
39.2 ~ 49.1 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)
