4.
Remove the valve (C) after removing the mounting bolt.
Turn the ignition switch OFF.
Disconnect the EGR Cooler bypass solenoid valve connector.
Measure resistance between the valve terminals 1 and 2.
Check that the resistance is within the specification.
Specification : 28.3 ~ 31.1 Ω [20℃(68℉)]
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Disconnect the EGR cooler bypass solenoid valve connector (A).
Disconnect the vacuum hoses (B) from the EGR cooler bypass solenoid valve.
Remove the valve (C) after removing the mounting bolt.
Install the component to the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Install in the reverse order of removal.
EGR cooler bypass solenoid valve mounting bolt:
6.8 ~ 10.7 N.m (0.7 ~ 1.1kgf.m, 5.1 ~ 8.0 lb-ft)
