3.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Accelerator Position | Output Voltage (V) [Vref = 5V] | |
APS1 | APS2 | |
C.T | 0.7 ~ 0.8 | 0.29 ~ 0.46 |
W.O.T | 3.85 ~ 4.35 | 1.93 ~ 2.18 |
Connect the GDS on the Data Link Connector (DLC).
Turn the ignition switch ON.
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
Accelerator Position | Output Voltage (V) [Vref = 5V] | |
APS1 | APS2 | |
C.T | 0.7 ~ 0.8 | 0.29 ~ 0.46 |
W.O.T | 3.85 ~ 4.35 | 1.93 ~ 2.18 |
Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Disconnect the accelerator position sensor connector (A).
Remove the installation bolt (C) and nuts (B), and then remove the accelerator pedal module.
Install in the reverse order of removal.
Accelerator pedal module mounting nut:
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)
Accelerator pedal module mounting bolt:
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)
