3.
Disconnect the crankshaft position sensor connector (A).
Check signal waveform of CMPS and CKPS using a GDS.
Specification: Refer ro "Signal Waveform"
Turn the ignition switch OFF and disconnect the battery (-) terminal.
Remove the air cleaner assembly.
(Refer to "Intake and Exhaust System" in EM group.)
Disconnect the crankshaft position sensor connector (A).
Remove the crankshaft position sensor (A) after removing the installation bolt.
Install the component to the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Install in the reverse order of removal.
Crank shaft position sensor mounting bolt:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
