1.
Inspect the wave form of BPS using GDS.
Pressure [kPa (kg/cm² / psi)] | Output Voltage (V) [Vref=5V] |
32.5 (0.33 / 4.71) | 0.5 |
284 (2.89 / 41.19) | 4.5 |
Inspect the wave form of BPS using GDS.
Pressure [kPa (kg/cm² / psi)] | Output Voltage (V) [Vref=5V] |
32.5 (0.33 / 4.71) | 0.5 |
284 (2.89 / 41.19) | 4.5 |
Turn the ignition switch OFF and disconnect the battery (-) cable.
Disconnect the boost pressure sensor connector (A).
Remove the boost pressure sensor (B) after removing the installation bolts.
Install the component to the specified torques.
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
Install in the reverse order of removal.
Boost pressure sensor mounting bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
