4.
Disconnect the water sensor connector (A) and the heater connector (B).
Turn ignition switch OFF and disconnect the negative (-) battery terminal.
Remove the air cleaner assembly.
(Refer to "Engine and transaxle assembly in EM group.)
Remove the battery and ECM.
(Refer to "Charging system" in EE group.)
Disconnect the water sensor connector (A) and the heater connector (B).
Disconnect the fuel inlet tube (A) quick-connector and the fuel outlet tube (B) quick-connector.
Remove the fuel filter assembly (B) after loosening the mounting nuts (A).
Remove the water sensor (A).
Remove the fuel filter assembly from the bracket after removing the bracket nuts (A) and replace it with a new one. Then, install the fuel filter assembly in the reverse order of the above steps.
When replacing the fuel filter, the O-ring must be replaced.
Bleed air in low pressure fuel circuit.
(Refer to "Air bleeding in low pressure fuel circuit")
Start the engine and check for any leakage from the low pressure fuel circuit including the fuel filter.
