Install in the reverse order of removal.
When installing the high pressure fuel pipe, tighten to the specified tightening torques by using the special service tool (SST No.:09314-27120).
After removing or replacing the following parts, bleed air in low pressure fuel circuit.
(Refer to "Air bleeding in low pressure fuel circuit" in this group.)
Fuel tank
Fuel sender
Fuel filter
High pressure fuel pump
Low pressure fuel lines
After removing or replacing fuel system below, the fuel leakage test procedure must be performed. (Refer to "Fuel leak test" in this group.)
Fuel tank
Fuel sender
Fuel filter
High pressure fuel pump
Injector
Common rail
Low pressure fuel line
