13666896

note

●

Thoroughly clean all parts to be assembled.

●

Before installing the parts, apply fresh engine oil to all sliding and rotating surfaces.

Install the valves.

(1)

Using the SST (09222-1S100), push in a new valve stem seal.

note

●

Do not reuse old valve stem seals.

●

Incorrect installation of the seal could result in oil leakage past the valve guides.

(2)

Install the valve, valve spring and spring retainer.

note

Place the valve springs so that the cone shape side faces the retainer above it.

(3)

Using the SST (09222 - 3K000, 09222-3K100), compress the spring and install the retainer locks. After installing the valves, ensure that the retainer locks are correctly in place before releasing the valve spring compressor.

(4)

Lightly tap the end of each valve stem two or three times with the wooden handle of a hammer to ensure proper seating of the valve and retainer lock.

Install the mechanical lash adjuster (A).

note

MLA can be reinstalled in its original position.

However, the valve lash clearances must be rechecked and adjusted accordingly before the cylinder head is installed onto the cylinder block.