3.
Remove the rear oil seal (A).
Remove the transaxle assembly.
(Refer to Manual Transaxle System - "Manual Transaxle")
Remove the flywheel.
(Refer to Cylinder Block Assembly - "Flywheel")
Remove the rear oil seal (A).
Using the SST (09214-03100, 09231-H1100) and a plastic hammer, tap in a new oil seal (A) until SST surface is flush with the cylinder block.
The depth of the oil seal (A) from the cylinder block surface should be 0.2 ~ 0.8 mm (0.0079 - 0.0315 in.).
Before assembling oil seal, the hardened sealant or hazardous material on the boundary area between cylinder block and ladder frame must be removed.
Apply engine oil to a new oil seal lip.
Install the oil seal by pressing it into the correct direction and be careful not to damage it.
Install the remaining parts in the reverse order of removal.
