1.
Install the jack to the edge of upper oil pan to support the engine.
note
Insert the rubber block between jack and oil pan.
Install the jack to the edge of upper oil pan to support the engine.
Insert the rubber block between jack and oil pan.
Disconnect the ground cable (A).
Tightening torque :
10.8 ~ 13.7 N.m (1.1 ~ 1.4 kgf.m, 8.0 ~ 10.1 lb-ft)
Remove the engine mounting support bracket (A).
Tightening torque
Nut (B) :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
Bolt (C), Nuts (D) :
58.8 ~ 73.5 N.m (6.0 ~ 7.5 kgf.m, 43.4 ~ 54.2 lb-ft)
Remove the reservoir tank.
(Refer to Cooling System - "Reservoir Tank")
Remove the engine mounting bracket (A).
Tightening torque :
63.7 ~ 83.3 N.m (6.5 ~ 8.5 kgf.m, 47.0 ~ 61.5 lb-ft)
Install in the reverse order of removal.
Remove the roll rod bracket (A).
Tightening torque
Bolts (B):
49.0 ~ 63.7 N.m ( 5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)
Nut (C):
107.9 ~ 127.5 N.m (11.0 ~ 13.0 kgf.m, 79.6 ~ 94.0 lb-ft)
Remove the roll rod mounting support bracket (A).
Tightening torque :
49.0 ~ 68.6 N.m ( 5.0 ~ 7.0 kgf.m, 36.2 ~ 50.6 lb-ft)
Install in the reverse order of removal.
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
Remove the under cover.
Install the jack to the edge of transaxle.
Remove the cover (A).
Remove the transaxle support bracket mounting bolt (A).
Tightening torque :
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
Remove the transaxle mounting bracket (A).
Tightening torque :
63.7 ~ 83.3 N.m (6.5 ~ 8.5 kgf.m, 47.0 ~ 61.5 lb-ft)
Install in the reverse order of removal.
