3.
Unfasten the compressor lower mounting bolts (A).
Remove the under cover.
Drain the engine oil.
(Refer to Lubrication System - "Engine Oil")
Unfasten the compressor lower mounting bolts (A).
Remove the intercooler inlet hose & pipe.
(Refer to Intake And Exhaust System - "Intercooler")
Remove the roll rod mounting bracket.
(Refer to Engine And Transaxle Assembly - "Engine Mounting")
Remove the oil pan acoustic shield (A).
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Unfasten the transaxle lower mounting bolts (A).
Tightening torque :
34.3 ~ 49.0 N.m (3.5 ~ 5.0 kgf.m, 25.3 ~ 36.2 lb-ft)
Remove the oil pan cover (A).
Remove the oil pan (A).
When removing the oil pan, use the SST(09215-3C000) in order not to damage the surface between the bedplate and the oil pan.
Insert the SST between the oil pan and the bed plate by tapping it with a plastic hammer in the direction of ① arrow.
After tapping the SST with a plastic hammer along the direction of ② arrow around more than 2/3 edge of the oil pan, remove it from the bed plate.
Do not turn over the SST abruptly without tapping as it may damage the SST.
Remove the baffle plate (A).
Remove the oil strainer (A).
