3.
Disconnect the solenoid valve connector (A).
Turn ignition switch OFF.
Remove the air cleaner assembly.
(Refer to Engine Mechanical System - "Air cleaner")
Disconnect the solenoid valve connector (A).
Measure the resistance between power terminal (10) and signal terminal (18).
Specification : 10.0 ~ 11.0 Ω
Remove the under cover.
(Refer to Engine Mechanical System - "Engine RoomUnder Cover")
Remove the drain plug (A) and drain the ATF totally and then reinstall the drain plug.
Tightening torque :
33.3 ~ 43.1 N.m (3.4 ~ 4.4 kgf.m, 24.6 ~ 31.8 lb-ft)
The existing ATF drain plug gasket must be replaced with new one. (Do not reuse it.)
Remove the air cleaner assembly.
Refer to Engine Mechanical System - "Air Cleaner")
Remove the wiring bracket (A).
Tightening torque :
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Remove the air breather hose (A).
Remove the valve body cover (B).
Tightening torque :
11.8~ 13.7 N.m (1.2 ~ 1.4 kgf.m, 8.7 ~ 10.1 lb-ft)
Remove the solenoid valve connector (B) and the oil temperature sensor (A).
Remove the solenoid valve (B) after removing the solenoid support (A).
Install in the reverse order of removal.
The existing solenoid valve O-ring (A) must be replaced with new one. (Do not reuse it.)
The existing valve body cover gasket (A) must be replaced with new one. (Do not reuse it.)
Refill the automatic transaxle with fluid.
(Refer to Hydraulic System - "Fluid")
Confirm that there is no fluid leakage on connections after repairing.
