4.
Disconnect the inhibitor switch connector (A) and loosen the shift cable mounting nut (B).
Disconnect the Inhibitor switch connector.
Ignition KEY "ON"" & Engine "OFF".
Measure voltge between supplied power and ground at inhibitor circuit.
Specification : Approx. 12V
Connect the Inhibitor switch connector.
Ignition KEY "ON" & Engine "OFF".
Measure voltages between each terminal and chassis ground during shift lever changed "P, R, N, D".
Specification : See below "Signal Code Table"
| P | P-R | R | R-N | N | N-D | D |
Signal "1" | 12V | 12V | 0 | 0 | 0 | 0 | 0 |
Signal "2" | 0 | 12V | 12V | 12V | 0 | 0 | 0 |
Signal "3" | 0 | 0 | 0 | 12V | 12V | 12V | 0 |
Signal "4" | 0 | 0 | 0 | 0 | 0 | 12V | 12V |
Place the shift lever into the "N" position.
Remove the air duct and the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
Remove the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
Disconnect the inhibitor switch connector (A) and loosen the shift cable mounting nut (B).
Remove the manual control lever (B) and the washer after removing a nut (A).
Remove the inhibitor switch (A) after loosening the bolts.
Check that the shift lever is placed in the "N" position
Install the inhibitor switch (A).
Lightly tighten the inhibitor switch mounting bolts so that necessary adjustments can be made.
Install the manual control lever (A).
Lightly tighten the manual control lever nut so that necessary adjustments can be made.
Align the hole (B) in the manual control lever with the "N" position hole (A) of the inhibitor switch and then insert the SST inhibitor switch guide pin (09480-A3800).
Tighten the nut (A) and bolts (B) with the specified torque.
Tightening torque
A : 17.7 ~ 24.5 N.m (1.8 ~ 2.5 kgf.m, 13.0 ~ 18.1 lb-ft)
B : 9.8 ~ 1.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
Remove the SST (09480-A3800) from the adjusment hole.
Connect the inhibitor switch connector (A).
Install the shift cable by tightening nut (B).
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Install the battery and battery tray.
(Refer to Engine Electrical System - "Battery")
Install the air duct and the air cleaner assembly.
(Refer to Engine Mechanical System - "Air Cleaner")
