3.
Remove the ignition coil (A) after loosening the mounting bolts.
note
●
When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).
Disconnect the battery nagative terminal.
Remove the engine cover.
Remove the ignition coil (A) after loosening the mounting bolts.
When removing the ignition coil connector, pull the lock pin (A) and push the clip (B).
Install in the reverse order of removal.
Ignition coil mounting bolt:
9.8-11.8 N.m (1.0-1.2 kgf.m, 7.2-8.7 Ib-ft)
Measure the primary coil resistance between terminal 1 and 2.
Standard value: 0.74Ω ± 10% [20°C (68°F)]
