4.
Remove the cable from alternator "B" terminal (A).
Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
Remove the air cleaner.
(Refer to Engine Mechanical System - "Air Cleaner")
Remove the battery.
(Refer to Engine Electrical System - "Battery")
Remove the cable from alternator "B" terminal (A).
Remove the starter solenoid "B" terminal mounting nut, and then disconnect the starter cable (B) and ST connector (A).
Starter solenoid "B" terminal tightening nut:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 Ib-ft)
Remove the starter mounting upper bolt (A).
Starter mounting bolt:
42.2 ~ 53.9 N.m (4.3 ~ 5.5 kgf.m, 31.1 ~ 39.8 lb-ft)
Lift the vehicle.
Remove the engine room under cover (A) after loosening the mounting bolts.
Remove the side cover RH (A) after loosening the mounting bolts.
Using a hexagon wrench, loosen the tensioner (A) by turning it clockwise.
Remove the drive belt (B).
Disconnect the oil pressure switch connector (A).
Disconnect the compressor connector, and then by loosening the mounting bolts, widen the gap between the compressor (A) from the engine to remove the starter.
Remove the starter mounting under bolt (A).
Starter mounting bolt:
42.2 ~ 53.9 N.m (4.3 ~ 5.5 kgf.m, 31.1 ~ 39.8 lb-ft)
Remove the starter (A).
