Component Inspection
1.

Ignition "OFF"

2.

Disconnect the battery (-) terminal cable from the battery and wait at least one minutes.

3.

Refer to "Shop Manual" and remove Side Impact Sensor Front-Passenger.

4.

Measure resistance between Pin No. 1 (Low) terminal and Pin No. 2 (High) terminal of Side Impact Sensor Front-Passenger.

Specification : Approx. 2.5 MΩ (Actual Vehicle Test Vaule)

Fig.1) GDS Multimeter resistance check

5.

Are the measured value within specification?

▶ If no problems were found with the circuits or connectors, Replace the SRSCM main circuit and go to "Verification of Vehicle Repair" procedure.

▶ If no problems were found with the circuits or connectors, Replace the Side Impact Sensor Front-Passenger and go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика