If a misfire exists that exceeds the threshold value, the PCM sets DTC P0300.
Item | Detecting Condition | Possible Cause | |
DTC Strategy |
•
Multiple Misfire | 1. Poor connection 2. Ignition system 3. Fuel system 4. Intake/exhaust air system 5. Ignition timing 6. Injector 7. Bad quality fuel | |
Case 1 | Enable Conditions |
•
Engine speed greater than 510 rpm and less than 6500 rpm
•
Engine load greater than Zero torque
•
Time after engine start greater than 0 sec
•
ECT at starting below -7℃(19.4 °F) greater than 21 ℃(69.8 °F), Else ECT equal to or greater than -7 ℃(19.4 °F)
•
No rough road detection
•
Remark : (Rough Road Condition Check) Wheel acceleration less than 30~40 m/s | |
Threshold Value |
•
Misfire rate greater than 3.0% per 1000 rev. | ||
Diagnostic Time |
•
1000 rev. | ||
MIL ON Condition |
•
2 driving cycle | ||
Case 2 | Enable Conditions |
•
Engine speed greater than 510 rpm and less than 6500 rpm
•
Engine load greater than Zero torque
•
Time after engine start greater than 0 sec
•
ECT at starting greater than -10 °C(14 °F) | |
Threshold Value |
•
Catalyst temperature over 1050 °C(1922 °F) greater than 6~20% | ||
Diagnostic Time |
•
200 rev. | ||
MIL ON Condition |
•
1 driving cycle | ||
