9258238

Component Inspection

Ignition Switch "OFF"

Disconnect batter (-) cable.

Refer to "Shop Manual" and disconnect the FTS connector.

Refer to "Shop Manual" and remove the FTS.

Measure resistance between Pin No. 2(Signal) and Pin No. 1(Ground) of the FTS.

Specification : Refer to the chart below.

※ Temperature is inversely proportional with resistance.

Temp.(℃)	-30	-20	-10	0	20	40	50	60	70	80
Resistance (kΩ)	27	15.67	9.45	5.89	2.27 ~ 2.73	1.17	0.83	0.6	0.43	0.30 ~ 0.32

Is the measured value within specification?

	▶ Fault is intermittent caused by poor contact in the sensor’s and/or ECM’s connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of vehicle Repair" procedure.
	▶ If no problems were found with the circuits or connectors, Replace the FTS unit and go to "Verification of Vehicle Repair" procedure. warning • When install a part, tighten it within specification. • When drop down the part, check part's operating condition whether it is damaged or not.