Ignition "OFF".
Disconnect Battery (-) terminal.
Refer to "Shop Manual" and disconnect Sports Mode Switch connector.
Operate Sports Mode Switch.
Measure resistance between Pin No. 7 (Signal) terminal of Sports Mode Switch harness connector and chassis ground.
Specification : Sports Mode Selected : Approx. below 1 Ω / Sports Mode Not Selected : Infinite(∞) Ω
Is measured value within specification?
![]() | ▶ Go to next procedure. |
![]() | ▶ Carefully re-do this troubleshooting guide steps. ▶ If problem still occurs, replace Sports Mode Switch and then go to "Verification of Vechicle Repair" procedure. |
Ignition "OFF".
Connect GDS to Data Link Connector(DLC).
Ignition "ON".
Operate Shift Lever Switch.
Monitor "Shift Lever Switch" and "Sports Mode Select" parameter in "Current Data" with GDS.
Specification : Refer to Figure below
Is displayed parameter within specification?
![]() | ▶ Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors ( and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage. ▶ Repair or replace as necessary and then go to "Verification of Vehicle Repair" procedure. |
![]() | ▶ Carefully re-do this troubleshooting guide steps. ▶ If problem still occurs, replace TCU and then go to "Verification of Vechicle Repair" procedure. |