Component Inspection
■ Visual Inspection
1.

Repair if the clutch pedal and switch is abnormally installed.

■ Inspect clutch switch
2.

IG KEY "OFF"

3.

Disconnect clutch switch connector.

4.

Check continuity between clutch switch component signal terminal and Ground terminal as depressing clutch pedal.

Specification :

Clutch pedal depressed : Continuity (below 2Ω)

Clutch pedal released : Discontinuity (Infinite Ω)

5.

Is the measured value within specification?

▶ Many malfunctions in the electrical system are caused by poor harness(es) and terminals. Faults can also be caused by interference from other electrical systems, and mechanical or chemical damage. So, check poor connections and the related circuit between ECM/PCM and component thoroughly. Repair as necessary and go to "Verification of Vehicle Repair" procedure.

▶ Substitute with a known - good Clutch Switch and check for proper operation.

If the problem is corrected, replace Clutch Switch and go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика