Component Inspection
█ Check clutch S/W
1.

Ignition Switch "OFF"

2.

Connect VMI to GDS and select oscilloscope.(2 Channel)

Channel A (+) : Pin No. 1(signal) connector (On clutch S/W Connector)

Channel A (-) : Ground

3.

Ignition switch "ON" & engine "OFF"

4.

Inspection condition : clutch S/W On/Off

Specification : Clutch Switch Off - B+

Clutch Switch On - Approx. 0V

5.

Is the measured value within specification?

▶ Fault is intermittent caused by poor contact in the sensor’s and/or ECM’s connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of vehicle Repair" procedure.

▶ If no problems were found with the circuits or connectors, Replace the clutch S/W and go to "Verification of Vehicle Repair" procedure.

Яндекс.Метрика